Skyjacker FJ730K Manuel d'utilisateur télécharger pdf

Part # Description Qty

TOY20153-S 2.5-3" COIL-2" COIL 2

SKY201-S SKYJACKER 2" SHOCK 2

T5USM-B UPPER SHOCK MOUNT 2

T5SBB-S SWAY BAR LWRG BLOCK 2

FJ25R 2.5" REAR COILS FJ 1

SBE702 END LINKS REAR 1

Front Installation:

1. With the vehicle on flat level ground, measure from center of the

front spindle to the top of the fender opening. Record this

measurement for later use.

2. Raise the front of the vehicle in the center of the front cross member,

using a floor jack.

3. Support the vehicle on the frame cross member so that the front tires

/ wheels are off the ground & remove the front tires / wheels.

4. Remove the ABS line from the upper A-arms using a 10mm wrench.

(See Photo # 1) Disconnect ABS / brake line from the steering

knuckle.

5. Remove the sway bar end links using 17mm. (See Arrow in Photo

# 2)

6. Remove the cotter pin from the outer tie rod & disconnect tie rod

using a 12 mm socket. (See Photo # 3)

Pg 1

I-FJ730 REV2 12-12

IMPORTANT NOTES

-Skyjacker strongly advises taking extreme caution when working with loaded coil springs to

prevent accident or harm.

-Trucks w/o manual locking hubs, the height must not be adjusted over 2" above OEM height.

-Both coil over assemblies should be adjusted to the same length (19 7/8" center to center)

after installation. It is VERY IMPORTANT that after installation, the coil does not have any

slack between the mounting cups. At no time during axle travel should the coils lose

contact with the mounting points.

-When final adjustments are made, the set screw MUST be tightened. At no time should the

coil over assembly be ran without the set screw being tight.

2007- 2012 Toyota FJ Cruiser 2.5"- 3”

Platinum Series Coil Over

Installation Instructions

Part # FJ730K

www.skyjacker.com

Photo # 1

Photo # 2

Photo # 3

1 2 3 4

Résumé du contenu

Page 1 - Front Installation:

Part # Description QtyTOY20153-S 2.5-3" COIL-2" COIL 2SKY201-S SKYJACKER 2" SHOCK

Page 2

Pg 2 7. Remove the cotter pin from the upper ball joint & remove using a 19mm socket. (See Photo # 4) 8. Locate the lower shock mounting b

Page 3 - Rear Installation:

15. Reattach the ABS line / brake line & sway bar end links.16. Reinstall the front tires / wheels & lower the vehicle to the ground.Rear Inst

Page 4

FINAL NOTES:* After the installation is complete, double check that all nuts & bolts are tight. * Check to ensure there is adequate clearance betw

Commentaires sur ces manuels

Pas de commentaire

Skyjacker FJ730K Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Skyjacker FJ730K. Skyjacker FJ730K User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Skyjacker FJ730K