Skyjacker FA650 Manuel d'utilisateur télécharger pdf

Installation:

1. Park the vehicle on level ground, set the emergency brake, &

block the rear tires / wheels.

2. Remove the OEM drag link assembly from the pitman arm.

Loosen the pitman arm nut from the steering sector using a

1 13/16” socket. (See Photo # 1) Using a pitman arm puller,

remove the pitman arm from the sector. (See Photo # 2)

3. Note: Before installing the new Skyjacker pitman arm, it is

extremely important that the following steps be followed. The

dri-lock compound on the threads of the OEM nut & the threads

on the steering sector shaft must be thoroughly cleaned off &

the threads dried before applying thread locking compound.

4. Using the supplied thread locking compound, apply a heavy bead

all the way around the entire threads of the nut. (See Photo # 3)

Once the thread locking compound has been applied, install the

new Skyjacker pitman arm & OEM nut. Torque to 350 Ft. Lbs.

(See Photo # 4)

5. Reattach the OEM drag link assembly.

Seat Belts Save Lives, Please Wear Your Seat Belt.

2005 - 2011 Ford Super Duty

Pitman Arm

Installation Instructions

Part # FA450 / FA650

I-FA450 REV1 3-11 Pg 1

www.skyjacker.com

Photo #1

Photo #2

Photo #3

Photo #4

1 2

Installation:1. Park the vehicle on level ground, set the emergency brake, & block the rear tires / wheels.2. Remove the OEM drag link assembl

Check out our favorite ministries at:www.innministries.orgwww.familychurch.orgwww.kcm.orgJesus Forgives, Rocks Don’tJesus Christ Died For You.John

Modèles reliés FA450

Pas de commentaire